VoodooPowerMini 1.2.5 release edition requires restarting after wake from sleep

VoodooPower > Bug Reports

(1/2) > >>

Blackosx:
Hi Superhai

I am currently running 10.6.3 with Cartri's modified BIOS v0.7m for my GA-EP45-DS3L (don't think that makes a difference) and using VoodooMonitor.kext with the VoodooMonitor application to monitor stepping.

VoodooPowerMini v1.2.5 release edition is installed in /S/L/E and works great but after waking from sleep, stepping no longer works until I unload and reload the kext. Is there something I can do to avoid this?

On a side note, with 10.6.3, I have tried running VoodooPowerMini v1.2.5 Debug Edition but it fails to load.

Regards

Superhai:
Why doesn't the debug version load? It would be the only way to find out what doesn't work.

Blackosx:
I have tried using a different 10.6.3 installation on my machine and this time the debug version loads just fine.. So I must have an issue with my other installation, sorry about that :-[.

So using the other installation, I have taken a screenshot of my kernel.log before and after sleep to show the debug feedback, though there aren't any further message from VoodooPowerMini after wake from sleep.

Then I show a screenshot of the steps I use to unload and reload the kext, followed by another kernel log of the debug feedback.

Hope this gives you something to go on, or if there is more information that I can supply then just let me know.
Thanks

Superhai:
Try the beta 3 version found here and see what it reports.

http://superhai.com/beta-darwin.html

Blackosx:
Hi Superhai

Thanks for the update to test v1.2.7 b4. I have gone through the same process as last time but this time I have attached a zip with the four screenshots. Though the end result is the same with it still needing restarting before it functions again.

But here's the new debug output:

Before Sleep:

--- Code: ---Apr 28 07:08:50 BlackupSnow3 kernel[0]: Voodoo[0x5B7CAA3E] event: 405: State: 061A Idle (384/500) P-State 4 Trend Down Fail 0
--- End code ---

After sleeping, but then unloading and reloading the kext:

--- Code: ---Apr 28 07:12:56 BlackupSnow3 kernel[0]: Voodoo[0x5B982A3E] event: 405: State: 061A Idle (394/500) P-State 4 Trend Down Fail 0
--- End code ---

Hope that helps.
Regards

Navigation

[0] Message Index

[#] Next page

Go to full version