Hello.
I tried finding a post here on this forum where this was discussed, but I couldnt. I did find some others, but being a bit of a noob on Mac OS, I didnt quite find what to make of it.
My install works well, however I can only boot when the installer DVD is inserted, and I just let it go through it and boot the normal OSX install, not the installer. I downloaded Chameleon since that was one of the tips, installed it, but nothing new happend. Same screen with boot0:error in the end.
I am running one single partition, 1.5TB, its disk0s2 if I remember correctly, so it should be fairly easy to make it work. But allas, I dont seem to get it right, so I was hoping there would be a genious here that would take pity in my cause and help me out with the details.
Regards, Tom
Edit: Short update, when I go to the Startup Disk utility, the disk itself doesnt even show up. Its fitted with GUID bootloader (as far as I remember), just running the one partition with iDeneb 10.5.6, and nothing else is in the computer. Just Network boot that shows up in Startup Disk.