Usually one sees the GPT message, then the testing one, then an error one if you have an error. I don't.
I just see "boot0: error"
I installed 10.6 from a retail DVD on a new drive (a WD WD6400BEVT 640GB in a USB case) connected up to a MacBook Pro running Leopard. I successfully booted from it into SL from the MBP. I then updated the installation to 10.6.2. Now I want to install that drive into my hackbook, and replace the existing Leopard (iPC 10.5.6) installed HD.
I connected the new WD drive via USB to my hackbook (it's rdisk1). I then followed the Chameleon EFI manual install (I have unix shell skillz, so no worries there). I used as my baseline, Conti's patch of Chameleon RC4 (Chameleon_v2.0-RC4_AsereBLN_myHack_v1.0-r111).
So yes, I did the mount_hfs of the EFI partition, installed boot0 with fdisk, installed boot1h to the bootsector of the EFI partition, copied boot to /Volumes/EFI, touched /Volumes/EFI/.fseventsd/no_log, made sure the EFI partition is flagged as active with fdisk, made sure that ignore permissions on both the SL partition and EFI partition are unchecked. I then installed my kexts, DSDT, plists, and made my Extensions.mkext. I then finished with the usual chmod -R 755, and chown -R root:wheel.
When I reboot, it's clearly booting from the USB, and I get the boot0 error. I can't think of what I've missed, except:
1. Does Chameleon RC4 get confused if there are other disks with a Chameleon bootloader present? (My main Leopard on the internal hard disk (iPC 10.5.6 uses Chameleon).
Could use some help here. Thanks!!