Hello,
I have a big problem. I have been following munky’s guide on how to install the EFI bootloader to use a vanilla install of Mac OS X on my hackintosh. Before, I have succeeded in making my own Boot-132 cd for my AMD machine using hecker’s guide on
http://www.insanelymac.com/forum/index.php?showtopic=140683 .
The installation of chameleon RC1 on my EFI partition worked fine. But during boot, when it should load the Aqua interface, nothing happens. There is also no message about the “LoginWindowApplication” printed on the screen.
Using my boot-132, everything works fine.
I have tried to boot up without any kexts which did not work because I need the AppleNForceATA.kext for my hard drive. I have also tried to boot up only with this single kext, and also with this one and with my video driver (NVinject) but the GUI does not show up either. I have exactly the same kexts on my boot-132 cd and it works fine with that.
I have an AMD Athlon 64 4000+, an nForce based motherboard and I’m using the Voodoo Kernel 9.5.0
Could there be a bug in the bootloader that causes this problem?
I have had some contact to hecker, the creator of the AMD guide. The correspondence can be found at
http://www.insanelymac.com/forum/index.php?showtopic=140683&pid=1121273&mode=threaded&start=#entry1121273maybe it’s useful.